Example For Configuring The Default Md For Ethernet Cfm - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability

4.18.4 Example for Configuring the Default MD for Ethernet CFM

In this example, you can configure the default MD on a device in a low-level MD. A high-level
MD can detect topology changes in a low-level MD.
Networking Requirements
As shown in
D, Switch E, and Switch F are managed by ISP 2. The CFM function can be enabled after the
default MD is configured on the device in a low-level MD.
Figure 4-15 Networking diagram for configuring the default MD for Ethernet CFM
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Issue 01 (2011-10-26)
ma ma1
map vlan 2
mep mep-id 1 interface Ethernet0/0/1 inward
mep ccm-send mep-id 1 enable
remote-mep mep-id 2
remote-mep ccm-receive mep-id 2 enable
remote-mep mep-id 3
remote-mep ccm-receive mep-id 3 enable
#
return
Figure 4-15, Switch B and Switch C are managed by ISP 1, and Switch A, Switch
VLAN2
Eth0/0/3
Eth0/0/1
SwitchA
Eth0/0/2
VLAN3
Switch IEEE 802.1ag Draft 7 to IEEE Standard 802.1ag-2007.
Create VLANs and add interfaces to the VLANs.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchC
SwitchB
SwitchD
MEP of MA1
MEP of MA2
MIP
4 Ethernet OAM Configuration
VLAN3
SwitchE
Eth0/0/2
SwitchF
Eth0/0/1
VLAN2
226