Example For Configuring Single-Hop Bfd On A Vlanif Interface; Huawei Proprietary And Confidential - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Bind Peer IP Address
NextHop Ip Address
Bind Interface
FSM Board Id
Min Tx Interval (ms)
Actual Tx Interval (ms): 1000
Local Detect Multi
Echo Passive
Destination Port
Proc Interface Status
WTR Interval (ms)
Active Multi
Last Local Diagnostic
Bind Application
Session TX TmrID
Session Init TmrID
Session Echo Tx TmrID
PDT Index
Session Description
--------------------------------------------------------------------------------
----End
Configuration Files
l
l
6.9.2 Example for Configuring Single-Hop BFD on a VLANIF
Interface
Networking Requirements
The S3700s are connected through the VLANIF interface at Layer 3. To detect the connectivity
of the link between two directly connected S3700s, you can configure single-hop BFD to bind
the BFD session to the VLANIF interface and its IP address.
As shown in
Switch A and Switch B.
Issue 01 (2011-10-26)
Total UP/DOWN Session Number : 1/0
Configuration file of Switch A
#
sysname SwitchA
#
bfd
#
bfd atob bind peer-ip default-ip interface Ethernet0/0/1
discriminator local 1
discriminator remote 2
commit
#
return
Configuration file of Switch B
#
sysname SwitchB
#
bfd
#
bfd btoa bind peer-ip default-ip interface Ethernet0/0/1
discriminator local 2
discriminator remote 1
commit
#
return
Figure 6-2, a BFD session is created to detect the connectivity of the link between

Huawei Proprietary and Confidential

Copyright © Huawei Technologies Co., Ltd.
: 224.0.0.184
: 224.0.0.184
: Ethernet0/0/1
: 0 TOS-EXP
: 1000 Min Rx Interval (ms)
Actual Rx Interval (ms): 1000
: 3 Detect Interval (ms)
: Disable Acl Number
: 3784 TTL
: Disable
: -
: 3
: No Diagnostic
: No Application Bind
: - Session Detect TmrID
: - Session WTR TmrID
: -
: FSM-0 | RCV-0 | IF-0 | TOKEN-0
: -
6 BFD Configuration
: 7
: 1000
: 3000
: -
: 255
: -
: -
305