Huawei Quidway S3700 Series Configuration Manual page 95

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
[SwitchD-rrpp-domain-region1] control-vlan 10
[SwitchD-rrpp-domain-region1] protected-vlan reference-instance 1
[SwitchD-rrpp-domain-region1] quit
# Disable STP on the interfaces to be added to the RRPP rings, configure the interfaces as trunk
interfaces, and configure the interfaces to allow service packets of VLAN 2 to VLAN 9 to pass
through.
[SwitchD] interface ethernet 0/0/1
[SwitchD-Ethernet0/0/1] port link-type trunk
[SwitchD-Ethernet0/0/1] port trunk allow-pass vlan 2 to 9
[SwitchD-Ethernet0/0/1] stp disable
[SwitchD-Ethernet0/0/1] quit
[SwitchD] interface ethernet 0/0/2
[SwitchD-Ethernet0/0/2] port link-type trunk
[SwitchD-Ethernet0/0/2] port trunk allow-pass vlan 2 to 9
[SwitchD-Ethernet0/0/2] stp disable
[SwitchD-Ethernet0/0/2] quit
[SwitchD] interface ethernet 0/0/3
[SwitchD-Ethernet0/0/3] port link-type trunk
[SwitchD-Ethernet0/0/3] port trunk allow-pass vlan 2 to 9
[SwitchD-Ethernet0/0/3] stp disable
[SwitchD-Ethernet0/0/3] quit
# Configure the primary interface and secondary interface of the transit node on the RRPP major
ring.
[SwitchD] rrpp domain 1
[SwitchD-rrpp-domain-region1] ring 1 node-mode transit primary-port ethernet 0/0/2
secondary-port ethernet 0/0/1 level 0
[SwitchD-rrpp-domain-region1] ring 1 enable
[SwitchD-rrpp-domain-region1] quit
# Configure the common interface and edge interface of the assistant edge node on the RRPP
subring.
[SwitchD] rrpp domain 1
[SwitchD-rrpp-domain-region1] ring 2 node-mode assistant-edge common-port ethernet
0/0/2 edge-port ethernet 0/0/3
[SwitchD-rrpp-domain-region1] ring 2 enable
[SwitchD-rrpp-domain-region1] quit
Step 5 Verify the configuration.
After the configurations are complete and network become stable, run the following commands
to verify the configuration:
l Run the display rrpp brief command on Switch B. The following information is displayed:
Issue 01 (2011-10-26)
[SwitchB] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status:
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 1
Domain Index : 1
Control VLAN : major 10
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec)
Ring Ring Node
ID Level Mode
------------------------------------------------------------------------------
1 0 M
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Enable
sub 11
Fail Timer : 6 sec(default is 6 sec)
Primary/Common
Port
Ethernet0/0/1
3 RRPP Configuration
Secondary/Edge
Port
Ethernet0/0/2
Is
Enabled
Yes
83