Huawei Quidway S3700 Series Configuration Manual page 265

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
l On UPEA, run the display rrpp brief or display rrpp verbose domain command. The result
Issue 01 (2011-10-26)
After the preceding configurations are complete and the network topology becomes stable,
perform the following operations to verify the configuration. Take the display on UPEA and
PE-AGG as examples.
is as follows:
# Check the brief information of RRPP on UPEA.
[UPEA] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 1
Domain Index : 1
Control VLAN : major 5
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec)
Ring Ring Node Primary
ID Level Mode Port
----------------------------------------------------------------------------
1 0 T Ethernet0/0/1
RRPP is enabled on UPEA, VLAN 5 is the control VLAN and VLANs mapping instance 1
are the protected VLANs in domain 1, and UPE A is a transit node on ring 1; Eth 0/0/1 is
the primary interface, and Eth 0/0/2 is the secondary interface.
# Check detailed information about UPEA in domain 1.
[UPEA] display rrpp verbose domain 1
Domain Index : 1
Control VLAN : major 5
Protected VLAN: Reference Instance 1
ello Timer : 1 sec(default is 1 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Transit
Ring State : LinkUp
Is Enabled : Enable
Primary port : Ethernet0/0/1
Secondary port: Ethernet0/0/2
The preceding information shows that VLAN 5 is the control VLAN in domain 1, and VLANs
mapping instance 1 are the protected VLANs; UPEA is a transit node in domain 1 and is in
LinkUp state; RRPP is enabled on UPEA.
# Check the brief information of RRPP on PE-AGG.
[PE-AGG] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 1
Domain Index : 1
Control VLAN : major 5
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec)
Ring Ring Node
ID Level Mode
Enabled
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
sub 6
Fail Timer : 3 sec(default is 3 sec)
Secondary/Edge
Port
Ethernet0/0/2
sub 6
Fail Timer : 3 sec(default is 3 sec)
Is Active : Yes
Port status: UP
Port status: UP
sub 6
Fail Timer : 3 sec(default is 3 sec)
Primary/Common
Port
4 Ethernet OAM Configuration
Yes
Secondary/Edge
Port
Is
Enabled
Is
253