Other Accessories; Hastings Power Supplies; Interconnecting Cables - Teledyne HASTINGS HFM-300 Instruction Manual

1.4. Other Accessories

1.4.1. Hastings Power supplies

Hastings Power Pod power supply/display units are available in one and four channel versions. They
convert 100, 115 or 230VAC to the ±15 VDC required to operate the flow meter and provide a digital
indication of the flow rate. Interface terminals for the retransmission of the flow meter analog output
signal are located on the rear of the panel.
The THCD-100 and Power Pod 400 models are built with controllers in mind but will work with meters
as well. The Model 40 is for flow meters only. Throughout this manual, when reference is made to a
power supply, it is assumed the customer is using a Hastings power supply. Hastings THCD-100 and
PowerPod-400 power supplies are CE marked. The THCD-100 is not compatible with 4–20 mA analog
signals. With the PowerPod 400, individual channels' input signals, as well as their commands, become
4–20 mA compatible when selected. The PowerPod-400 also sports a Totalizer feature. More
information about the Power Pods can be found on the Hastings web site. http://www.teledyne-
hi.com/products/powerpod-series.htm

1.4.2. Interconnecting Cables

Cables are available from Hastings, in various lengths, to connect from the 15 pin "D" connector on the
back of the Power Pod directly to any of the 200 series and 300 series flow instruments (including
digital versions). More information about the available cables can be found in the Power Pod 400
bulletin on the Hastings web site. http://www.teledyne-hi.com/pdfs/bulletins.htm
Manual: 151-032015 300-302 Series
Page 6 of 22