Service Information - Honda SH125 Manual

FRAME/BODY PANELWEXHAUST SYSTEM
SERVICE INFORMATION
GENERAL
This section covers removal and installation of the body panels and exhaust system.
When installing the covers, make sure the mating areas are aligned properly before tightening the fasteners.
Always replace the exhaust pipe gasket after removing the exhaust system.
When installing the exhaust system, loosely install all of the fasteners. Always tighten the exhaust joint first, then
tighten the mounting fasteners. If you tighten the mounting fasteners first, the exhaust pipe may not seat properly.
Always inspect the exhaust system for leaks after installation.
TORQUE VALUES
Center stand pivot bolt
Center stand spring hook bolt
Exhaust pipe stud bolt
Exhaust pipe joint nut
Muffler mounting bolt
Muffler protector bolt
49 N.m (5.0 kgf.m, 36 Ibf.ft) ALOC bolt: replace with a new one.
10 N.m (1.0 kgf.m, 7 Ibf.ft)
9 N.m (0.9 kgf.m, 6.6 Ibf.ft)
29 N.m (3.0 kgf.m, 21 Ibf.ft)
49 N.m (5.0 kgf.m, 36 Ibf.ft)
5.2 N.m (0.53 kgf.m, 3.8 Ibf.ft)
TROUBLESHOOTING
Excessive exhaust noise
Broken exhaust system
Exhaust gas leak
Poor performance
Deformed exhaust system
Exhaust gas leak
Clogged muffler
2-2