Crankcase Bearing Replacement; Left Crankcase Bearing Replacement - Honda 1998 VT750C Service Manual

CRANKSHAFT/TRANSMISSION
Apply molybdenum oil solution to the shift fork shaft.
Install the shift fork shaft with its stepped end side
facing up (right crankcase side).
After installing, check for smooth transmission opera-
tion.
Assemble the crankcase (page 12-22).
CRANKCASE BEARING REPLACEMENT
Remove the following:
- Crankshaft (page 12-6)
- Transmission (page 12-12)
- Oil pump (page 4-4)
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly and quietly. Also
check that the bearing outer race fits tightly in the
crankcase.
Replace the bearings if the races does not turn
smoothly and quietly, or if they fit loosely in the
crankcase.
LEFT CRANKCASE BEARING REPLACEMENT
Remove the left mainshaft bearing using the special
tools.
Remove the left countershaft bearing and oil seal.
Install the new bearings to the left crankcase using
the following special tools.
The oil pump
must be removed
before replacing
the crankcase
bearing.
Drive in the new
bearings squarely
with the marking
side facing up.
12-20
TOOLS:
Bearing remover set
- Remover handle
- Bearing remover head
- Remover sliding weight
TOOLS:
Mainshaft bearing:
Driver
Attachment, 42 X 47 mm
07936-3710001
Not available in U.S.A.
07936-3710100
07936-3710600
07741-0010201
or
07936-371020A
(U.S.A. only) or
07936-3710200
07749-0010000
07746-0010300
:I1BEARING