Reset Garp Statistics; Gvrp Configuration Commands; Display Gvrp Statistics - H3C S3100 Series Command Manual

Hide thumbs Also See for S3100 Series:

Table of Contents

# Set the GARP LeaveAll timer to 100 centiseconds.

<Sysname> system-view

System View: return to User View with Ctrl+Z.

[Sysname] garp timer leaveall 100

reset garp statistics

reset garp statistics [ interface interface-list ]

interface-list: Specifies a list of Ethernet ports. In this list, you can specify individual ports and port

ranges. An individual port takes the form of interface-type interface-number and a port range takes the

form of interface-type interface-number1 to interface-type interface-number2, with interface-number2

taking a value greater than interface-number1. The total number of individual ports and port ranges

defined in the list must not exceed 10.

Use the reset garp statistics command to clear the GARP statistics (including statistics about packets

received/sent/discarded by GVRP) on the specified or all ports.

Executing the reset garp statistics command without any parameter clears the GARP statistics of all

Related commands: display garp statistics.

# Clear GARP statistics of all ports.

<Sysname> reset garp statistics

display gvrp statistics [ interface interface-list ]

interface interface-list: Specifies an Ethernet port list. By providing a value for this argument, you can

display the GVRP statistics on the specified ports. You need to provide the interface-list argument in the

format of { interface-type interface-number [ to interface-type interface-number ] } &<1-10>, where the

interface-type argument represents the port type, the interface-number argument represents the port

number, and & <1-10> means that you can provide up to 10 port indexes/port index ranges for this

Table of Contents