Configure Gvrp; Display And Debug Garp; Gvrp Overview - Huawei Quidway S3500 Series Operation Manual

Operation Manual - VLAN
Quidway S3500 Series Ethernet Switches
Restore the default GARP Hold timer,
Join timer and Leave timer settings
Restore the default GARP LeaveAll
timer settings.
Note that, the value of Join timer should be no less than the doubled value of Hold timer,
and the value of Leave timer should be greater than the doubled value of Join timer and
smaller than the Leaveall timer value. Otherwise, the system will prompt message of
error.
By default, Hold timer is 10 centiseconds, Join timer is 20 centiseconds, Leave timer is
60 centiseconds, and LeaveAll timer is 1000 centiseconds.

3.1.3 Display and Debug GARP

After the above configuration, execute display command in any view to display the
running of GARP configuration, and to verify the effect of the configuration. Execute
reset command in user view to reset the configuration of GARP. Execute debugging
command in user view to debug the configuration of GARP.
Table 3-2 Display and debug GARP
Display
information
Display GARP timer
Clear GARP statistics information
Enable GARP event debugging
Disable GARP event debugging

3.2 Configure GVRP

3.2.1 GVRP Overview

GARP VLAN Registration Protocol (GVRP) is a GARP application. Based on GARP
operating mechanism, GVRP provides maintenance of the dynamic VLAN registration
information in the switch and propagates the information to other switches. All the
GVRP-supporting switches can receive VLAN registration information from other
Operation
Operation
GARP statistics
Huawei Technologies Proprietary
Chapter 3 GARP/GVRP Configuration
undo garp timer { hold | join | leave }
undo garp timer leaveall
Command
display garp
interface-list ]
display garp timer [ interface interface-list ]
reset garp statistics [ interface interface-list ]
debugging garp event
undo debugging garp event
3-3
Command
statistics [ interface