Huawei Quidway S3500 Series Operation Manual page 590

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
1) Enabling info-center
Perform the following operation in system view.
Table 4-20 Enable/disable info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to loghost
Perform the following operation in system view.
Table 4-21 Configuring to output information to loghost
Output information to loghost
Cancel the configuration of
outputting
loghost
Note:
Ensure to enter the correct IP address using the info-center loghost command to
configure loghost IP address. If you enter a loopback address, the system prompts of
invalid address appears.
3) Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following operation in system view.
Operation
Operation
information to
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
info-center enable
undo info-center enable
Command
info-center loghost host-ip-addr [ channel
{ channel-number | channel-name } ] [ facility
local-number ] [ language { chinese | english } ]
undo info-center loghost host-ip-addr
4-13
Command