Display And Debug Access Management; Access Management Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches
S3526E/S3526E FS/S3526E FM/S3526C switches support this configuration in
S3500 series switches.
8.2.6 Enable/Disable Access Management Trap
You can use the following command to enable/disable access management trap.
Perform the following configuration in System view.
Table 8-7 Enable/Disable access management trap
Enable access management trap
Disable access management trap
By default, the access management trap is disabled.

8.3 Display and debug Access Management

After the above configuration, execute display command in any view to display the
current configurations of access management on the ports, and to verify the effect of
the configuration.
Table 8-8 Display current configuration of access management
Display current configuration
of access management
Display Port, IP address and
MAC address binding
Note that S3526E/S3526E FM/S3526E FS/S3526C switches support display am
user-bind command in S3500 series switches.

8.4 Access Management Configuration Example

I. Networking requirements
Organization 1 is connected to the port 1 of the switch, and organization 2 to the port 2.
The ports 1 and 2 belong to the same VLAN. The IP addresses ranging
202.10.20.1~202.10.20.20 can be accessed from the port 1 and those ranging
202.10.20.21~202.10.20.50 from the port 2. Organization 1 and organization 2 cannot
communicate with each other.
Operation
Operation
Huawei Technologies Proprietary
Chapter 8 Access Management Configuration
am trap enable
undo am trap enable
Command
display am [ interface-list ]
display am user-bind [ interface { interface-name |
interface-type interface-number } | mac-addr mac |
ip-addr ip ]
8-6
Command