Configure Router Port Aging Time - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Multicast
Quidway S3500 Series Ethernet Switches
Enabling/Disabling the function of fast removing a port from a multicast group
Setting the maximum number of multicast groups permited on a port
Configuring IGMP Snooping Filter
Among the above configuration tasks, enabling IGMP Snooping is required, while
others are optional for your requirements.
3.2.1 Enable/Disable IGMP Snooping
You can use the following commands to enable/disable IGMP Snooping to control
whether MAC multicast forwarding table is created and maintained on Layer 2.
Perform the following configuration in system view.
Table 3-1 Enable/Disable IGMP Snooping
Enable/disable IGMP Snooping
Restore the default setting
IGMP Snooping and GMRP cannot run at the same time. You can check if GMRP is
running, using the display gmrp status command, in any view, before enabling IGMP
Snooping.
By default, IGMP Snooping is disabled.

3.2.2 Configure Router Port Aging Time

This task is to manually configure the router port aging time. If the switch has not
received any general query message from the router before the router port is aged, it
will remove the port from all the MAC multicast group.
Perform the following configuration in system view.
Table 3-2 Configure router port aging time
Configure router port aging time
Restore the default aging time
By default, the port aging time is 260s.
Operation
Operation
Huawei Technologies Proprietary
Chapter 3 IGMP Snooping Configuration
Command
igmp-snooping { enable | disable }
undo igmp-snooping
Command
igmp-snooping router-aging-time seconds
undo igmp-snooping router-aging-time
3-5