Overview Of Bootp Client; Bootp Client Configuration - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches
Chapter 7 BOOTP Client Configuration
Note:
This chapter only applies to S3552G, S3552P, S3528G, S3528P, S3552F, S3526E,
S3526E FM, S3526E FS and S3526C in S3500 series switches.

7.1 Overview of BOOTP Client

BOOTP client can request the server to allocate an IP address to it using BOOTP
(bootstrap protocol). These two major processes are included on the BOOTP client:
Sending BOOTP Request message to the server
Processing BOOTP Response message returned from the server
In obtaining IP address using BOOTP, BOOTP client sends the server the BOOTP
Request message. Upon receiving the request message, the server returns the
BOOTP Response message. BOOTP client then can obtain the allocated IP address
from the received response message.
The BOOTP message is based on UDP, so retransmission mechanism in the event of
timeout is used to guarantee its reliable transmission. BOOTP client also starts a
retransmission timer when it sends the request message to the server. If the timer
expires before the return of the response message from the server, the request
message will be retransmitted. The retransmission occurs every five seconds and the
maximum number of retransmission is 3, that is, the message shall not be
retransmitted after the third time.

7.2 BOOTP Client Configuration

BOOTP client configuration includes:
Configuring a VLAN interface to obtain the IP address using BOOTP
7.2.1 Configuring a VLAN Interface to Obtain the IP Address Using BOOTP
Perform the following configuration in VLAN interface
Huawei Technologies Proprietary
7-1
Chapter 7 BOOTP Client Configuration
view.