Sending The Configuration Information To Console Terminal - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
The configuration on the loghost must be the same with that on the switch. For related
configuration, see the configuration examples in the later part.

4.5.4 Sending the Configuration Information to Console terminal

To send configuration information to console terminal, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-24 Enable/disable info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to console terminal
Perform the following operation in system view.
Table 4-25 Configuring to output information to console terminal
Output information to Console
Cancel
outputting information to Console
3) Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following operation in system view:
Operation
Operation
the configuration of
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
info-center enable
undo info-center enable
Command
info-center
channel{ channel-number | channel-name }
undo info-center console channel
4-15
Command
console