Enable/Disable A Stack; Switch To A Slave Switch View To Perform The Configuration - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches
Table 1-1 Configure IP address pool for the stack
Configure IP address range
for a stack
Restore to the default IP
address range
Before setting up a stack, the user should configure a public IP address pool for the
slave switch of the stack.
Please note that the above configurations can only be performed on the non-stack
switches. After a stack is enabled, the user is prevented from modifying the IP address
pool.

1.2.2 Enable/Disable a Stack

When the user enables a stack with the following command, the system will
automatically add the switches, connected to the main switch via stack ports, to the
stack. After a stack has been enabled, if the stack port is disconnected, slave switch will
exit the stack automatically.
Perform the following configuration in system view.
Table 1-2 Enable/Disable a stack
Enable a stack
Disable a stack
Please note that you can only operate on the main switch to disable a stack.

1.2.3 Switch to a Slave Switch view to Perform the Configuration

The following command can be used to switch from the main switch view to a slave
switch view to change the configuration.
Please perform the following configurations in user view.
Table 1-3 Switch to a slave switch view to perform the configuration
Switch to a slave switch view to
perform the configuration
Operation
Operation
Operation
Huawei Technologies Proprietary
Chapter 1 Stack Function Configuration
Command
stacking ip-pool
ip-address-number [ ip-mask ]
undo stacking ip-pool
stacking enable
undo stacking enable
stacking num
1-2
from-ip-address
Command
Command