Configuration Tasks; Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches

2.3.2 Configuration Tasks

The following table describes the gratuitous ARP configuration tasks:
Table 2-6 Configure gratuitous ARP
Configuration item
Enter system view
Enable gratuitous ARP
packet sending
Enable gratuitous ARP
packet learning
Use the corresponding undo command to cancel the configuration.

2.3.3 Configuration Example

I. Network requirements
Enable gratuitous ARP packet sending and learning on the switch Quidway A.
II. Configuration procedure
<QuidwayA> system-view
[QuidwayA] arp send-gratuitous enable
[QuidwayA] gratuitous-arp-learning enable
2.4 Display and debug ARP
After the above configuration, execute display command in any view to display the
running of the ARP configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug ARP configuration. Execute reset
command in user view to clear ARP mapping table.
Table 2-7 Display and debug ARP
Display ARP mapping table
Display the ARP timed probing
information
Display the current setting of the
dynamic ARP map aging timer
system-view
arp
enable
gratuitous-arp-learning
enable
Operation
Huawei Technologies Proprietary
2-6
Command
—
Required; by default, the
send-gratuitous
gratuitous ARP packet
sending is enabled.
Required. by default, the
gratuitous ARP packet
learning is disabled.
Command
display arp [ static | dynamic | ip-address ]
display arp probe [ interface vlan-interface
vlan-id ]
display arp timer aging
Chapter 2 ARP Configuration
Description