Sending The Configuration Information To Snmp Network Management - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
Table 4-41 Configuring the output format of time-stamp
Configure the output format of
the time-stamp
Output time-stamp is disabled

4.5.8 Sending the Configuration Information to SNMP Network Management

To send configuration information to SNMP NM, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-42 Enabling/disabling info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to SNMP NM
Perform the following operation in system view.
Table 4-43 Configuring to output information to SNMP NM
Output information to SNMP NM
Cancel
outputting information to SNMP NM
3) Configuring information source on the switch
By this configuration, you can define the information that sent to SNMP NM is
generated by which modules, information type, information level, and so on.
Operation
Operation
Operation
the configuration
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
Command
info-center timestamp {
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
info-center enable
undo info-center enable
info-center
{ channel-number | channel-name }
of
undo info-center snmp channel
4-24
log | trap
Command
Command
snmp channel
|