Setting Up Configuration Environment Through A Dial-Up The Modem - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Getting Started
Quidway S3500 Series Ethernet Switches
Step 1: Authenticate the Telnet user via the Console port on the Telnet Server (switch)
before login.
Note:
By default, the password is required for authenticating the Telnet user to log in the
switch. If a user logs in via the Telnet without password, he will see the prompt "Login
password has not been set !".
<Quidway> system-view
[Quidway] user-interface vty 0
[Quidway-ui-vty0] set authentication password simple xxxx (xxxx is the preset login
password of Telnet user)
Step 2: The user logs in the Telnet Client (switch). For the login process, refer to the
section describing "Connecting a PC to the Switch through Telnet".
Step 3: Perform the following operations on the Telnet Client:
<Quidway> telnet xxxx (xxxx can be the hostname or IP address of the Telnet Server. If
it is the hostname, you need to use the ip host command to specify.)
Step 4: Enter the preset login password and you will see the prompt such <Quidway>. If
the prompt "All user interfaces are used, please try later!" appears, it indicates that too
many users are connected to the switch through the Telnet at this moment. In this case,
please connect later.
Step 5: Use the corresponding commands to configure the switch or view it running
state. Enter "?" to get the immediate help. For details of specific commands, refer to the
following chapters.
2.3 Setting up Configuration Environment through a Dial-up
the Modem
Step 1: Authenticate the Modem user via the Console port of the switch before he logs
in the switch through a dial-up Modem.
Note:
By default, the password is required for authenticating the Modem user to log in the
switch. If a user logs in via the Modem without password, he will see an error prompt.
<Quidway> system-view
Huawei Technologies Proprietary
2-5
Chapter 2 Logging in Switch