Operation Manual - Port
Quidway S3500 Series Ethernet Switches
If correct, configure the link aggregation again.
II. For S3526E/S3526C/S3552G/S3552P/S3528G/S3528P/S3552F Ethernet
Switches, take the following steps
Check the input parameter and see whether the starting number of Ethernet port is
smaller than the end number. If yes, take the next step.
Check whether the Ethernet ports that are in the configured range belong to any
other existing link aggregations. If not, take the next step.
Check whether the ports to be aggregated operate in the same speed and full
duplex mode. If yes, take the next step.
Check if there are no more than eight ports in one group.
If correct, configure the link aggregation again.
Huawei Technologies Proprietary
2-4
Chapter 2 Link Aggregation Configuration