Sending The Configuration Information To Loghost - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
Table 4-18 Sending the configuration information to SNMP
Device
Switch
Network
managemen
t workstation
7) Turn on/off the information synchronization switch in Fabric
Table 4-19 Turn on/off the information synchronization switch in Fabric
Device
Switch

4.5.3 Sending the Configuration Information to Loghost

To send configuration information to loghost, follow the steps below:
Configuration
Enable info-center
Set the information
output direction to
SNMP
Set information
source
Configuring SNMP
features
The same as the
SNMP
configuration of the
switch
Configuration
Enable By default, info-center
info-center is enabled.
By default, switches of
master log in Fabric,
debugging and trap
Set the information
information synchronization
output direction turned on, so as log
to SNMP and strap information
synchronization
switches
switches.
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
Default value Configuration description
By default, Other
info-center is valid only if the info-center is
enabled. enabled.
- -
You
modules and information to
be
time-stamp
- information, and so on. You
must turn on the switch of the
corresponding
before
debugging information.
See Chapter 5
-
Configuration
- -
Default value
are
in other
4-12
configurations
can define
sent out and
format
module
defining
SNMP
Configuration description
Other configurations
valid only if the info-center
is enabled.
This configuration can keep
log information, debugging
information and
information in Fabric in
every switch synchronized.
are
which
the
of
output
are
trap