Huawei Quidway S3500 Series Operation Manual page 125

Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches
Delete the client MAC address in the
static binding
By default, no static address binding is configured for any global DHCP address pool.
Note:
The static-bind ip-address command must be used along with the static-bind
mac-address command. If you use the command repeatedly, the new configuration
will overwrite the previous one.
II. Configure static address binding for a VLAN interface address pool
Perform the following configuration in VLAN interface view. Each VLAN interface
address pool supports multiple IP-MAC address bindings.
Table 5-7 Configure static address binding for the VLAN interface address pool
Configure a static address binding in the
current VLAN interface address pool
Delete the static address binding in the
current VLAN interface address pool
By default, no static address binding is configured for any VLAN interface address pool.
III. Configure dynamic address allocation
To dynamically allocate addresses to clients (including permanent and temporary
leases) using an address pool, you should assign an address range to the pool.
Perform the following configuration in DHCP address pool view.
Table 5-8 Configure an IP address range for dynamic allocation
Configure an IP address range for dynamic
allocation.
Delete the IP address range for dynamic
allocation.
Operation
Operation
Operation
Huawei Technologies Proprietary
5-9
Chapter 5 DHCP Configuration
Command
undo static-bind mac-address
Command
dhcp server static-bind ip-address
ip-address mac-address mac-address
undo dhcp server
{ ip-address
mac-address mac-address }
Command
network ip-address [ mask netmask ]
undo network
static-bind
ip-address |