Distribute Load Among Dhcp Servers - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches
Table 5-30 Configure DHCP server address to which the current VLAN interface relays
packets
Configure DHCP server address to which
the current VLAN interface relays packets
Remove one or all the DHCP server
addresses to which the current VLAN
interface relays packets
II. Configure DHCP server address to which the specified multiple VLAN
interfaces relays packets
Perform the following configuration in system view.
Table 5-31 Configure DHCP server address to which the specified multiple VLAN
interfaces relays packets
Configure DHCP server address to which
the specified multiple VLAN interfaces
relays packets
Remove one or all the DHCP server
addresses to which the specified multiple
VLAN interfaces relay packets

5.4.2 Distribute Load among DHCP Servers

When multiple DHCP servers are configured corresponding to a DHCP Relay, it can
distribute among them the requests from DHCP clients by means of polling, thus
distributing the load.
Perform the following configuration in system view.
Table 5-32 Distribute the load among DHCP servers
Distribute the load among DHCP servers.
Disable load sharing among DHCP servers.
By default, DHCP servers do not share the load and all the requests from DHCP clients
are to be handled by the DHCP server configured first.
Operation
Operation
Operation
Huawei Technologies Proprietary
5-20
Chapter 5 DHCP Configuration
Command
ip relay address ip-address
undo ip relay address { ip-address |
all }
Command
ip relay address
{ interface vlan-interface vlan_id [ to
vlan-interface vlan_id ] | all }
undo ip relay address { ip-address |
all } { interface vlan-interface vlan_id
[ to vlan-interface vlan_id ] | all }
Command
ip relay address cycle
undo ip relay address cycle
ip-address