Configuration Examples Of Sending Log To Console Terminal - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
Note:
Note the following points when editing /etc/syslog.conf:
The note must occupy a line and start with the character #.
There must be a tab other than a space as the separator in selector/actor pairs.
No redundant space after file name.
The device name and the acceptant log information level specified in
/etc/syslog.conf must be consistent with info-center loghost and info-center loghost
a.b.c.d facility configured on the switch. Otherwise, the log information probably
cannot be output to the loghost correctly.
Step 3: After the establishment of information (log file) and the revision of
/etc/syslog.conf, you should view the number of syslogd (system daemon) through the
following command, kill syslogd daemon and reuse -r option the start syslogd in
daemon.
# ps -ae | grep syslogd
147
# kill -9 147
# syslogd -r &
Note:
For Linux loghost, you must ensure that syslogd daemon is started by -r option.
After the above operation, the switch system can record information in related log files.
Note:
To configure facility, severity, filter and the file syslog.conf synthetically, you can get
classification in great detail and filter the information.

4.5.13 Configuration examples of sending log to console terminal

I. Networking Requirement
The networking requirement are as follows:
Sending the log information of the switch to console terminal
Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-31