User Interface Configuration - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Getting Started
Quidway S3500 Series Ethernet Switches

4.2 User Interface Configuration

User interface configuration includes:
Entering user interface view
Configuring the user interface-supported protocol
Configuring the attributes of AUX (Console) port
Configuring the terminal attributes
Managing users
Configuring redirection
4.2.1 Entering User Interface View
The following command is used for entering a user interface view. You can enter a
single user interface view or multi user interface view to configure one or more user
interfaces respectively.
Perform the following configuration in system view.
Table 4-1 Entering user interface view
Enter a single user interface view or multi
user interface views
4.2.2 Configuring the User Interface-Supported Protocol
The following command is used for setting the supported protocol by the current user
interface. You can log in switch only through the supported protocol. The configuration
becomes effective when you log in again.
Perform the following configurations in user interface (VTY user interface only) view.
Table 4-2 Configuring the user interface-supported protocol
Configure the user interface-supported
protocol
By default, the user interface supports Telnet and SSH protocols.
S3526, S3526 FM, and S3526 FS of the S3500 series switches do not support the
configuration with the SSH parameter.
Operation
Operation
Huawei Technologies Proprietary
4-2
Chapter 4 User Interface Configuration
Command
user-interface [ type ] first-number
[ last-number ]
Command
protocol inbound { all | ssh | telnet }