Specifying The Operating State Of The Interface - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
processing will be refused. As there is no zero fields in the RIP-2 packet, this
configuration is invalid for RIP-2.
Perform the following configurations in RIP view.
Table 3-5 Configuring zero field check of the interface packet
Configure zero field check on the RIP-1 packet
Disable zero field check on the RIP-1 packet
By default, RIP-1 performs zero field check on the packet.

3.2.6 Specifying the operating state of the interface

In the Interface view, you can specify the operating state of RIP on the interface. For
example, whether RIP operates on the interface, namely, whether RIP update packets
are sent and received on the interface. In addition, whether an interface sends or
receives RIP update packets can be specified separately.
Perform the following configuration in Interface view:
Table 3-6 Specifying the operating state of the interface
Enable the interface to run RIP
Disable the interface to run RIP
Enable the interface to receive RIP update packet
Disable the interface to receive RIP update packet
Enable the interface to send RIP update packet
Disable the interface to send RIP update packet
The undo rip work command and the undo network command have similar but not all
the same functions. Neither of the two commands configures interface receiving or
sending RIP route. But in the undo rip work status, other interfaces still forward the
route of the interface applying this command, while in the undo network status, other
interface will no more forward the route of the interface applying this command, and it
seems that this interface has been removed.
In addition, rip work is functionally equivalent to both rip input and rip output
commands.
By default, all interfaces except loopback interfaces both receive and transmit RIP
update packets.
Operation
Operation
Huawei Technologies Proprietary
3-5
Chapter 3 RIP Configuration
Command
checkzero
undo checkzero
Command
rip work
undo rip work
rip input
undo rip input
rip output
undo rip output