Sending The Configuration Information To Trap Buffer - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
Table 4-37 Configuring the output format of time-stamp
Configure the output format of
the time-stamp
Output time-stamp is disabled

4.5.7 Sending the Configuration Information to Trap Buffer

To send configuration information to trap buffer, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-38 Enabling/disabling info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to trap buffer
Perform the following operation in system view.
Table 4-39 Configuring to output information to trap buffer
Output information to trap buffer
Cancel
outputting information to trap
buffer
Operation
Operation
Operation
the configuration of
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
Command
info-center timestamp {
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
info-center enable
undo info-center enable
Command
info-center trapbuffer [ size buffersize ]
[ channel { channel-number | channel-name } ]
undo info-center trapbuffer [ channel | size ]
4-22
log | trap
Command
|