Configure The Port (Not) To Connect With The Point-To-Point Link - Huawei Quidway S3500 Series Operation Manual

Operation Manual - STP
Quidway S3500 Series Ethernet Switches
You can configure the port priority in the following ways.
I. Configure in system view
Perform the following configuration in system view.
Table 1-16 Configure the port priority
Configure
priority.
Restore the default port
priority.
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-17 Configure the port priority
Configure the port priority.
Restore the default port priority.
You can configure the port priority with either of the above-mentioned measures. For
more about the commands, refer to the Command Manual.
Upon the change of port priority, MSTP will recalculate the port role and transit the state.
Generally, a smaller value represents a higher priority. If all the Ethernet ports of a
switch are configured with the same priority value, the priorities of the ports will be
differentiated by the index number. The change of Ethernet port priority will lead to
spanning tree recalculation. You can configure the port priority per actual networking
requirements.
By default, the priority of all the Ethernet ports is 128.

1.2.12 Configure the Port (not) to Connect with the Point-to-Point Link

The point-to-point link directly connects two switches.
You can configure the port (not) to connect with the point-to-point link in the following
ways.
I. Configure in system view
Perform the following configuration in system view.
Operation
the port
stp interface interface-list instance instance-id port
priority priority
undo stp interface interface-list instance instance-id
port priority
Operation
Huawei Technologies Proprietary
Chapter 1 MSTP Region-configuration
Command
Command
stp [ instance instance-id ] port priority
priority
undo stp [ instance instance-id ] port priority
1-21