Displaying And Debugging Bootp Client - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches
Table 7-1 Configuring a VLAN interface to obtain the IP address using BOOTP
Configure VLAN interface to obtain IP
address using BOOTP
Remove the configuration
By default, the VLAN interface cannot use BOOTP to get IP address.

7.3 Displaying and Debugging BOOTP Client

After the above configuration, execute display command in any view to display the
running of the BOOTP client configuration, and to verify the effect of the configuration.
Execute debugging command in user view to debug BOOTP client.
Table 7-2 Displaying and debugging BOOTP client
Display information of BOOTP client
Disable/enable BOOTP client debugging
Operation
Operation
Huawei Technologies Proprietary
7-2
Chapter 7 BOOTP Client Configuration
Command
ip address bootp-alloc
undo ip address bootp-alloc
Command
display bootp client [ interface
vlan-interface vlan_id ]
[ undo ] debugging bootp client