Multicast Vlan Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Multicast
Quidway S3500 Series Ethernet Switches
Defining the type of the
port to hybrid
Specifying VLANs for
the port
To cancel the configurations, use the corresponding undo commands.
Note:
The isolate vlan cannot be set to a multicast VLAN.
Only one multicast VLAN can be specified for a port.
The type of the ports connected with user terminals can only be hybrid.

9.3 Multicast VLAN Configuration Example

I. Network requirements
The devices and requirements are as follows:
Table 9-3 Devices and their requirements in the example
Device
Switch A
Switch B
PC 1
PC 2
Perform the following multicast VLAN configuration to allow users in VLAN 2 and VLAN
3 to receive multicast streams through the multicast VLAN.
Item
port link-type hybrid
port hybrid vlan vlan_id_list
{ tagged | untagged }
Role
The IP address of the VLAN 20 interface is
168.10.1.1; The port E1/0/1 belongs to VLAN 20 and
is connected with the workstation.
Layer 3 switch
VLAN 10 acts as a multicast VLAN.
The port E1/0/10 is connected with switch B.
VLAN 2 includes the port E1/0/1, which is connected
with PC1; the VLAN 3 includes the port E1/0/2, which
Layer 2 switch
is connected with PC2.
The port E1/0/10 is connected with switch A.
User 1 PC1 is connected with switch B through port E1/0/1.
User 2 PC2 is connected with switch B through port E1/0/2.
Huawei Technologies Proprietary
Command
Description
9-3
Chapter 9 Multicast VLAN
Description
Required
Required