Turn On/Off The Information Synchronization Switch In Fabric - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
4) Configuring of SNMP and network management workstation on the switch
You have to configure SNMP on the switch and the remote workstation to ensure that
the information is correctly sent to SNMP NM. Then you can get correct information
from network management workstation. SNMP configuration on switch refers to
Chapter 5 SNMP Configuration.

4.5.9 Turn on/off the Information Synchronization Switch in Fabric

After the forming of a Fabric by switches which support the XRN, the log, debugging
and trap information among the switches is synchronous. The synchronization process
is as follows: each switch sends its own information to other switches in the Fabric and
meantime receives the information from others, and then the switch updates the local
information to ensure the information coincidence within the Fabric.
The switch provides command line to turn on/off the synchronization switch in every
switch. If the synchronization switch of a switch is turned off, it does not send
information to other switches but still receives information from others.
1) Enable info-center
Perform the following operation in system view.
Table 4-46 Enable/disable info-center
Enable info-center
Disable info-center
2) Turn on the information synchronization switch
Perform the following operation in system view.
Table 4-47 Turn on/off the information synchronization switch of every switch
Turn on the information synchronization
switch of the specified switch
Turn off the information synchronization
switch of the specified switch
You can turn on/off the synchronization switch of the specified information on the
specified switch as needed.
Operation
Operation
Huawei Technologies Proprietary
4-26
Chapter 4 System Maintenance and Debugging
Command
info-center enable
undo info-center enable
Command
info-center switch-on { unit-id | master
| all } [ debugging | logging |
trapping ]*
undo info-center switch-on { unit-id |
master | all } [ debugging | logging |
trapping ]*