Operation Manual - Port
Quidway S3500 Series Ethernet Switches
Table 1-1 Enter Ethernet port view
Enter Ethernet port view
1.2.2 Enable/Disable Ethernet Port
The following command can be used for disabling or enabling the port. After configuring
the related parameters and protocol of the port, you can use the following command to
enable the port. If you do not want a port to forward data any more, use the command to
disable it.
Perform the following configuration in Ethernet port view.
Table 1-2 Enable/Disable an Ethernet port
Disable an Ethernet port
Enable an Ethernet port
By default, the port is enabled.
1.2.3 Set Description Character String for Ethernet Port
To distinguish the Ethernet ports, you can use the following command to make some
necessary descriptions.
Perform the following configuration in Ethernet port view.
Table 1-3 Set description character string for Ethernet port
Set description character string for Ethernet port.
Delete the description character string of Ethernet.
By default, the port description is a null character string.
1.2.4 Set Duplex Attribute of the Ethernet Port
To configure a port to send and receive data packets at the same time, set it to
full-duplex. To configure a port to either send or receive data packets at a time, set it to
half-duplex. If the port has been set to auto-negotiation mode, the local and peer ports
will automatically negotiate about the duplex mode.
Operation
Operation
Operation
Huawei Technologies Proprietary
Chapter 1 Ethernet Port Configuration
Command
interface
{
interface_type
interface_name }
shutdown
undo shutdown
1-3
interface_num
Command
Command
description text
undo description
|