Display And Debug Mstp - Huawei Quidway S3500 Series Operation Manual

Operation Manual - STP
Quidway S3500 Series Ethernet Switches
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-25 Enable/Disable MSTP on a port
Enable MSTP on a port.
Disable MSTP on a port.
You can enable/disable MSTP on a port with either of the above-mentioned measures.
For more about the commands, refer to the Command Manual.
Note that redundant route may be generated after MSTP is disabled.
By default, MSTP is enabled on all the ports after it is enabled on the device.

1.3 Display and Debug MSTP

After the above configuration, execute display command in any view to display the
running of the MSTP configuration, and to verify the effect of the configuration. Execute
reset command in user view to clear the statistics of MSTP module. Execute
debugging command in user view to debug the MSTP module
Table 1-26 Display and Debug MSTP
Show
information about the current
port and the switch.
Show
information about the region.
Clear
information.
Enable/Disable MSTP (packet
receiving/transmitting,
error) debugging on the port.
Enable/Disable the global MSTP
debugging.
Enable/Disable
debugging
Operation
Operation
the configuration
the configuration
the MSTP statistics
event,
specified STI
Huawei Technologies Proprietary
Chapter 1 MSTP Region-configuration
stp enable
stp disable
Command
display stp instance instance-id [ interface
interface-list [ brief ]
display stp region-configuration
reset stp [ interface interface-list ]
[ undo ] debugging
interface-list ] { packet | event }
[ undo ] debugging stp { global-event |
global-error | all }
[ undo ] debugging stp instance instance-id
1-27
Command
stp [ interface