Displaying And Debugging Static Route; Typical Static Route Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches

2.3 Displaying and Debugging Static Route

After the above configuration, execute display command in any view to display the
running of the Static Route configuration, and to verify the effect of the configuration.
Table 2-4 Displaying and debugging the routing table
View routing table summary
View routing table details
View the detailed information of a
specific route
View the route information in the
specified address range
View
specified basic access control list
(ACL)
View the route information that through
specified ip prefix list
View the routing information found by
the specified protocol
View the tree routing table
View the statistics of the routing table

2.4 Typical Static Route Configuration Example

I. Networking requirements
As shown in the figure below, the masks of all the IP addresses in the figure are
255.255.255.0. It is required that all the hosts or S3500 Series Ethernet Switches can
be interconnected in pairs by configuring static routes.
Operation
the route filtered
Huawei Technologies Proprietary
Chapter 2 Static Route Configuration
display ip routing-table
display ip routing-table verbose
display ip routing-table ip_address
[ mask ] [ longer-match ] [ verbose ]
display ip routing-table ip_address1
mask1 ip_address2 mask2 [ verbose ]
through
display
{ acl-number | acl-name } [ verbose ]
display ip
ip-prefix-name [ verbose ]
display ip
protocol [ inactive | verbose ]
display ip routing-table radix
display ip routing-table statistics
2-4
Command
ip routing-table
routing-table ip-prefix
routing-table protocol
acl