Setting Radius Server State; Configuring The Quiet Time Interval - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Security
Quidway S3500 Series Ethernet Switches
By default, the newly created RADIUS scheme supports the server of standard type,
while the "system" RADIUS scheme created by the system supports the server of
huawei type.

3.3.13 Setting RADIUS Server State

For the primary and second servers (no matter it is an authentication/authorization
server or accounting server), if the primary is disconnected to NAS for some fault, NAS
will automatically turn to exchange packets with the second server. However, after the
primary one recovers, NAS will not resume the communication with it at once, instead,
it continues communicating with the second one. When the second one fails to
communicate, NAS will turn to the primary one again. The following commands can be
used to set the primary server to be active manually, in order that NAS can
communicate with it right after the troubleshooting.
When the primary and second servers are both active or block, NAS will send the
packets to the primary server only.
Perform the following configurations in RADIUS scheme view.
Table 3-22 Setting RADIUS server state
Set the state of primary RADIUS
server
Set the state of second RADIUS
server
By default, the state of each server in RADIUS scheme is active.

3.3.14 Configuring the Quiet Time Interval

Note:
Among S3500 series ethernet switches, S3552G, S3552P, S3528G, S3528P, S3526E,
S3526E FM, S3526E FS and S3526C support this function, and S3526, S3526 FM and
S3526 FS don't.
The following commands can be used for setting the quiet time interval after which the
primary and secondary RADIUS servers switch over. The functions of the quiet time
interval are as follows:
The switch sends RADIUS packets to the primary RADIUS server.
Operation
Huawei Technologies Proprietary
3-18
Chapter 3 AAA and RADIUS Protocol Configuration
Command
state primary
authentication } { block | active }
state secondary{
authentication } { block | active }
{
accounting
accounting
|
|