Huawei Quidway S3500 Series Operation Manual page 224

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Delete a peer from the peer group
Reset connections of all members in
the peer group (in user view)
III. Configuring the state of a peer/peer group
BGP peer/peer group has two types of state: enable and disable. The BGP speakers do
not exchange routing information with the disabled peer or peer group.
Perform the following configurations in BGP view.
Table 5-4 Configuring the state of a peer/peer group
Enable a peer/peer group
disable a peer/peer group
By default, a peer or peer group is enabled.
IV. Configuring description of a peer (group)
Description of a peer (group) can be configured to facilitate learning the characteristics
of the peer .
Table 5-5 Configuring description of a peer (group)
Configure description of a
peer (group)
Delete description of a peer
(group)
By default, no BGP peer (group) description is set.
V. Configuring timer of peer (group)
The peer timer command is used to configure timers of BGP peer (group), including
the keep-alive message interval and the hold timer. The preference of this command is
higher than the timer command that is used to configure timers for the whole BGP
peers.
Operation
Operation
Operation
Huawei Technologies Proprietary
undo peer
group-name
reset bgp group group-name
Command
peer { group-name | peer-address } enable
undo peer { group-name | peer-address } enable
Command
peer { peer-address | group-name } description
description-line
undo peer { peer-address | group-name }
description
5-6
Chapter 5 BGP Configuration
Command
peer-address group