Configuring Packet Redirection; Configuring Priority Marking - Huawei Quidway S3500 Series Operation Manual

Operation Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches
Table 2-17 Configuring port traffic limit
Configure the port traffic limit
Cancel the configuration port traffic limit
Ethernet Switch supports the function of configuring configure a traffic limit for a single
port.
For details about the command, refer to the Command Manual.

2.3.5 Configuring Packet Redirection

Packet redirection is to redirect the packets to be forwarded to CPU or other output
port.
You can use the following command to configure the packet redirection.
Perform the following configuration in system view.
Table 2-18 Configuring redirection
Operation
Configure
redirection
Cancel
redirection
configuration
Note that the packets redirected to the CPU will not be dealt.
Note:
The configuration of redirection only takes effects on the rules with action permit.
For details about the command, refer to the Command Manual.

2.3.6 Configuring Priority Marking

The priority marking configuration is a policy to tag the priority for the packets matching
the ACL. The new priority can be filled in the priority field of the packet header.
You can use the following command to configure the priority marking.
Operation
traffic-redirect { user-group { acl-number | acl-name } [ rule
rule ] | { ip-group { acl-number | acl-name } [ rule rule ] |
link-group { acl-number | acl-name } [ rule rule ] }* } { cpu |
{ interface interface-name | interface-type interface-num } }
the undo traffic-redirect { user-group { acl-number | acl-name }
[ rule rule ] | { ip-group { acl-number | acl-name } [ rule rule ] |
link-group { acl-number | acl-name } [ rule rule ] }* }
Huawei Technologies Proprietary
2-14
Chapter 2 QoS Configuration
Command
line-rate target-rate
undo line-rate
Command