Huawei Quidway S3500 Series Operation Manual page 596

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
Note:
When there are more than one Telnet users or monitor users at the same time, some
configuration parameters should be shared among the users, such as module-based
filtering settings and severity threshold. When a user modifies these settings, it will be
reflected on other clients.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
Table 4-32 Configuring the output format of time-stamp
Configure the output format of
the time-stamp
Output time-stamp is disabled
4) Enabling terminal display function
To view the output information at the Telnet terminal or dumb terminal, you must first
enable the corresponding log, debugging and trap information functions at the switch.
For example, if you have set the log information as the information sent to the Telnet
terminal or dumb terminal, now you need to use the terminal logging command to
enable the terminal display function of log information on the switch, then you can view
the information at the Telnet terminal or dumb terminal.
Perform the following operation in user view:
Operation
Huawei Technologies Proprietary
4-19
Chapter 4 System Maintenance and Debugging
Command
info-center timestamp {
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
log | trap |