Display And Debug Stack Function; Stack Function Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches
Please note that the above command can only be used for switching from the main
switch view to a slave switch view and the user level remains the same after switching.
To switch from a slave switch view back to a main switch view, input quit.

1.3 Display and Debug Stack Function

After the above configuration, execute display command in any view to display the
running of the stack configuration, and to verify the effect of the configuration.
Table 1-4 Display and Debug Stack Function
Display the stack state information on
the main switch
Display the stack state information on a
slave switch
When using this command on the main switch, if the input parameter "members" is
omitted, you will find the displayed information indicating that the local switch is the
main switch and also the number of switches in the stack. Using the command with
members, you will find the member information of the stack, including stack number of
main/slave switches, stack name, stack device name, MAC address and status etc.
When using this command on a slave switch, you will find in the displayed information
of the slave switch of the stack, the stack number of the switch and MAC address of the
main switch in the stack.

1.4 Stack Function Configuration Example

I. Networking requirements
Switch A, Switch B, and Switch C are stacked together through the stack ports. Switch
A is the main switch. Switch B and Switch C are slave switches. The network
administrator manages Switch B and Switch C through Switch A.
Operation
Huawei Technologies Proprietary
1-3
Chapter 1 Stack Function Configuration
Command
display stacking [ members ]
display stacking