Implementation Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Auto Detecting
Quidway S3500 Series Ethernet Switches
Table 2-1 Configure auto detect for a static route
Operation
Enter system view
Bind a detecting group
to a static route
Refer to the corresponding command manual for more information about the
parameters listed in the above table and the related undo commands.

2.2.2 Implementation Example

I. Network requirements
Create a detecting group numbered 8 on Switch A.
Configure a static route between Switch A and Switch B.
Enable the static route when the result of detecting group 8 is reachable.
II. Network diagram
VLAN 1 VLAN 1
Ethernet 1/0/1 Ethernet 1/0/1
Ethernet 1/0/1 Ethernet 1/0/1
192.168.1.1 192.168.1.1
192.168.1.1/24 192.168.1.1/24
VLAN 2 VLAN 2
Ethernet 2/0/1 Ethernet 2/0/1
Ethernet 2/0/1 Ethernet 2/0/1
192.168.2.1 192.168.2.1
192.168.2.1/24 192.168.2.1/24
Figure 2-1 Network diagram for static routing
III. Configuration procedure
Configure Switch A as follows:
# Enter system view.
<Quidway A> system-view
# Create a detecting group numbered 8 and enter its view.
[Quidway A] detect-group 8
<Quidway> system-view
[Quidway] ip route-static ip-address
{ mask | mask-length } { interface-type
interface-number
[ preference preference-value ] [ reject
| blackhole
group-number
192.168.1.2 192.168.1.2/24 192.168.1.2 192.168.1.2/24
Switch B Switch B Switch B Switch B
Switch A Switch A Switch A Switch A
192.168.2.2 192.168.2.2/24 192.168.2.2 192.168.2.2/24
Huawei Technologies Proprietary
2-2
Chapter 2 Implementations of Auto Detect
Command
| nexthop
] detect-group
10.1.1.3/24 10.1.1.3 10.1.1.3/24 10.1.1.3
Switch C Switch C Switch C Switch C
Switch D Switch D Switch D Switch D
20.1.1.2/24 20.1.1.2/24 20.1.1.2 20.1.1.2
Remarks
-
}
Required
10.1.1.4/24 10.1.1.4 10.1.1.4/24 10.1.1.4