Configuring The Attributes Of Aux (Console) Port - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Getting Started
Quidway S3500 Series Ethernet Switches
Caution:
If Telnet protocol is specified, to ensure a successful login via the Telnet, you must
configure the password by default.
If SSH protocol is specified, to ensure a successful login, you must configure the
local or remote authentication of username and password using the
authentication-mode
configuration fails if you configure authentication-mode password and
authentication-mode none. When you configure SSH protocol successfully for the
user interface, then you cannot configure authentication-mode password and
authentication-mode none any more.

4.2.3 Configuring the Attributes of AUX (Console) Port

The following commands can be used for configuring the attributes of the AUX
(Console) port, including speed, flow control, parity, stop bit and data bit.
Perform the following configurations in user interface (AUX user interface only) view.
I. Configuring the transmission speed on AUX (Console) port
Table 4-3 Configuring the transmission speed on AUX (Console) port
Configure the transmission speed on
AUX (Console) port
Restore the default transmission speed
on AUX (Console) port
By default, the transmission speed on AUX (Console) port is 9600bps.
II. Configuring the flow control on AUX (Console) port
Table 4-4 Configuring the flow control on AUX (Console) port
Configure the flow control on AUX
(Console) port
Restore the default flow control mode on
AUX (Console) port
By default, the flow control on the AUX (Console) port is none, that is, no flow control
will be performed.
scheme
Operation
Operation
Huawei Technologies Proprietary
4-3
Chapter 4 User Interface Configuration
command. The
protocol
Command
speed speed-value
undo speed
Command
flow-control { hardware | none |
software }
undo flow-control
inbound ssh