Ip Address Configuration Example; Display And Debug Ip Address - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches
Table 1-3 Configure IP address for a VLAN interface
Configure IP address for a VLAN interface
Delete the IP address of a VLAN interface
By default, the IP address of a VLAN interface is null.

1.3 Display and debug IP Address

After the above configuration, execute display command in any view to display the IP
addresses configured on interfaces of the network device, and to verify the effect of the
configuration.
Table 1-4 Display and debug IP address
Display all hosts on the network and the
corresponding IP addresses
Display the configurations of each interface

1.4 IP Address Configuration Example

I. Networking requirements
Configure the IP address as 129.2.2.1 and sub-net mask as 255.255.255.0 for the
VLAN interface 1 of the Ethernet Switch.
II. Networking diagram
Figure 1-3 IP address configuration networking
III. Configuration procedure
# Enter VLAN interface 1.
[Quidway] interface vlan-interface 1
Operation
Operation
Console cable
PC
Huawei Technologies Proprietary
Chapter 1 IP Address Configuration
ip address ip-address net-mask
[ sub ]
undo ip address [ ip-address
net-mask [ sub ] ]
display ip host
display ip interface interface-type
interface-number
Switch
1-5
Command
Command