Huawei Quidway S3500 Series Operation Manual page 71

Operation Manual - VLAN
Quidway S3500 Series Ethernet Switches
Table 1-8 Shut down/Enable VLAN interface
Shut down the VLAN interface
Enabling the VLAN interface
The operation of shutting down or enabling the VLAN interface has no effect on the
UP/DOWN status of the Ethernet ports on the local VLAN.
By default, when all the Ethernet ports belonging to a VLAN are in DOWN status, this
VLAN interface is also DOWN, i.e. this VLAN interface is shut down. When there is one
or more Ethernet ports in UP status, this VLAN interface is also UP, i.e. this VLAN
interface is enabled.
1.3 Protocol-Based VLAN Configuration
Note:
Currently,
Switches support the protocol-based VLAN configuration.
Protocol-based VLAN configuration includes:
Create/Delete a VLAN protocol type
Create/Delete the association between an port and a protocol-based VLAN
1.3.1 Create/Delete a VLAN Protocol Type
You can use the following command to create/delete a VLAN protocol type.
Perform the following configuration in VLAN view.
Table 1-9 Create/delete a VLAN protocol type
Operation
Create
protocol type
Delete an existing
VLAN protocol type
Operation
only Quidway S3552G/S3552P/S3528G/S3528P/S3552F
protocol-vlan [ procotol-index ] { at | ip [ ip_address
a VLAN [ net_mask ] ] | ipx { ethernetii | llc | raw | snap } | mode
{ ethernetii [ etype etype_id ] | llc [ dsap dsap_id [ ssap
ssap_id ] | ssap ssap_id ] | snap [ etype etype_id ] } }
undo protocol-vlan { protocol_index [ to protocol_end ] |
all }
Huawei Technologies Proprietary
shutdown
undo shutdown
Command
1-5
Chapter 1 VLAN Configuration
Command
Ethernet