Enable/Disable Snmp Agent To Send Trap; Set The Destination Address Of Trap - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
Table 5-3 Set the method of identifying and contacting the administrator
Set the method of identifying and contacting
the administrator
Restore the default method of identifying and
contacting the administrator

5.3.3 Enable/Disable SNMP Agent to Send Trap

The managed device transmits trap without request to the Network Management
Station to report some critical and urgent events (such as restart).
You can use the following commands to enable or disable the managed device to
transmit trap message.
Perform the following configuration in system view.
Table 5-4 Enable/Disable snmp agent to Send Trap
Operation
Enable to send
trap
Disable to send
trap

5.3.4 Set the Destination Address of Trap

You can use the following commands to set or delete the destination address of the
trap.
Perform the following configuration in system view.
Table 5-5 Set the destination address of trap
Operation
Set the
address of trap
Delete the destination
address of trap
Operation
snmp-agent trap enable [ standard [ authentication ]
[ coldstart ] [ linkdown ] [ linkup ] [ warmstart ] ]
undo snmp-agent trap enable [ standard [ authentication ]
[ coldstart ] [ linkdown ] [ linkup ] [ warmstart ] ]
snmp-agent target-host trap address udp-domain
destination host-addr
securityname community-string [ v1 | v2c | v3
[ authentication | privacy ] ]
undo snmp-agent target-host host-addr securityname
community-string
Huawei Technologies Proprietary
5-4
Chapter 5 SNMP Configuration
Command
snmp-agent
sysContact
undo snmp-agent
contact
Command
Command
[ udp-port udp-port-number
sys-info contact
sys-info
] params