Sending The Configuration Information To Telnet Terminal Or Dumb Terminal - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
To view the output information at the console terminal, you must first enable the
corresponding log, debugging and trap information functions at the switch.
For example, if you have set the log information as the information sent to the console
terminal, now you need to use the terminal logging command to enable the terminal
display function of log information on the switch, then you can view the information at
the console terminal.
Perform the following operation in user view:
Table 4-28 Enabling terminal display function
Enable terminal display function of debugging
information
Disable terminal display function of debugging
information
Enable terminal display function of log information
Disable terminal display function of log information
Enable terminal display function of trap information
Disable terminal display function of trap information
4.5.5 Sending the Configuration Information to Telnet Terminal or Dumb
Terminal
To send configuration information to Telnet terminal or dumb terminal, follow the steps
below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-29 Enable/disable Info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
Operation
Operation
Huawei Technologies Proprietary
4-17
Chapter 4 System Maintenance and Debugging
terminal debugging
undo
debugging
terminal logging
undo terminal logging
terminal trapping
undo terminal trapping
Command
info-center enable
undo info-center enable
Command
terminal