Configure The File Transmission Mode; Download Files By Means Of Tftp - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
Table 1-14 Configuration of the switch as TFTP client
Device
Switch
PC

1.4.2 Configure the File Transmission Mode

TFTP transmits files in two modes, binary mode for program files and ASCII mode for
text files. You can use the following commands to configure the file transmission mode.
Perform the following configuration in system view.
Table 1-15 Configure the file transmission mode
Configure the file transmission mode
By default, TFTP transmits files in binary mode.

1.4.3 Download Files by means of TFTP

To download a file, the client sends a request to the TFTP server and then receives
data from it and sends acknowledgement to it. You can use the following commands to
download files by means of TFTP.
Perform the following configuration in system view.
Table 1-16 Download files by means of TFTP
Download files by means of TFTP
Configuration
Configure IP address for
the VLAN interface of
the switch, in the same
network segment as that
of TFTP server.
Use the tftp command to
log into the remote TFTP
server for file uploading
and downloading.
Start TFTP server and
set authorized TFTP
directory.
Operation
Operation
Huawei Technologies Proprietary
Chapter 1 File System Management
Default
TFTP is right for the case where no
complicated
required between the client and
server. Make sure that the IP
--
address of the VLAN interface on
the switch is in the same network
segment as that of the TFTP
server.
- -
- --
tftp { ascii | binary }
tftp get //A.A.A.A/xxx.yyy mmm.nnn
1-12
Description
interactions
Command
Command
are