Portal Authentication-Free User And Free Ip Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Security
Quidway S3500 Series Ethernet Switches
Configure
authentication-free
users
Display the information
about
authentication-free user
and free IP address
configurations
Caution:
In the re-DHCP authentication mode, the IP address of an authentication-free user
and the primary IP address of the VLAN interface must be in the same network
segment. In the direct authentication mode, the IP address of an authentication-free
user and the IP address of the VLAN interface must be in the same network
segment.
The configuration takes effect only if the Portal is enabled for the VLAN where the
authentication-free user locates.
Layer 3 Portal authentication does not support the configurations of
authentication-free users.

2.3.2 Portal Authentication-Free User and Free IP Configuration Example

I. Network requirements
Configure Portal authentication for the switch, and configure the Portal operating
mode as direct authentication.
Before passing Portal authentication, the user can access the internal server 1.
The server 2 can access the Internet without passing the authentication.
Steps
portal
mac-address ip ip-address
vlan
{
interface_num
interface_name }
Portal
display portal [ free-ip |
free-user ]
Huawei Technologies Proprietary
Command
free-user mac
vlan_id interface
interface_type
2-12
Chapter 2 Portal Configuration
Description
You can configure up to
32 authentication-free
users.
|
—