Huawei Quidway S3500 Series Operation Manual page 70

Operation Manual - VLAN
Quidway S3500 Series Ethernet Switches
Perform the following configurations in system view.
Table 1-6 Specify/Remove VLAN interface
Create a new VLAN interface and enter
VLAN interface view
Remove the specified VLAN interface
Create a VLAN first before create an interface for it.
For this configuration task, vlan_id takes the VLAN ID.
1.2.7 Assign/Delete IP Address and Mask for/of a VLAN Interface
To implement the network layer function on a VLAN interface, VLAN interface should
be set the IP address and mask. You can use the following command to set or delete
the IP address and mask for the VLAN interface.
Generally, it is enough to configure one IP address for an interface. You can also
configure 10 IP addresses for an interface, so that it can be connected to several
subnets. Among these IP addresses, one is the primary IP address and all others are
secondary.
Perform the following configuration in VLAN interface view.
Table 1-7 Assign/Delete IP address and mask for/of a VLAN interface
Assign the IP address and mask for a
VLAN interface
Delete the IP address and mask of a
VLAN interface
1.2.8 Shut down/Enable VLAN Interface
You can use the following command to shut down/enable VLAN interface.
Perform the following configuration in VLAN interface view.
Operation
Operation
Huawei Technologies Proprietary
1-4
Chapter 1 VLAN Configuration
Command
interface vlan-interface vlan_id
undo interface vlan-interface vlan_id
Command
ip address ip-address net-mask [ sub ]
undo ip address [ ip-address net-mask
[ sub ] ]