Huawei Quidway S3500 Series Operation Manual page 225

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Table 5-6 Configuring timer of peer (group)
Configure
interval and hold timer of peer
(group)
Restore the default value of
keep-alive message interval and
hold timer of a peer (group)
By default, the keep-alive message is sent every 60 seconds and the value of the hold
timer is 180 seconds.
VI. Configuring the interval at which route update messages are sent by a peer
(group)
Table 5-7 Configuring the interval at which route update messages are sent by a peer
(group)
Configure the route update message
interval of a peer (group)
Restore the default route update
message interval of a peer (group)
By default, the intervals at which route update messages are sent by an IBGP and
EBGP peer (group) are 5 seconds and 30 seconds respectively.
5.2.3 Configuring application features of BGP peer (group)
I. Configuring to Permit Connections with EBGP Peers (groups) on Indirectly
Connected Networks
Generally, EBGP peers must be connected physically. Otherwise the command below
can be used to perform the configuration in order to make them communicate with each
other normally.
Table 5-8 Configuring to permit connections with EBGP peers (groups) on indirectly
connected networks
Configure to permit connections
with EBGP peers (groups) on
indirectly connected networks
Operation
keep-alive message
Operation
Operation
Huawei Technologies Proprietary
5-7
Chapter 5 BGP Configuration
Command
peer { group-name | peer-address } timer
keep-alive keepalive-interval
holdtime-interval}
undo peer { group-name | peer-address }
timer
Command
peer { peer-address | group-name }
route-update-interval seconds
undo peer { peer-address | group-name }
route-update-interval
Command
peer { peer-address
ebgp-max-hop [ ttl ]
hold
| group-name }