Operation Manual - Auto Detecting
Quidway S3500 Series Ethernet Switches
Chapter 1 Configuring Auto Detecting
Note:
Quidway S3552F /S3552G /S3552P /3528G /3528P /S3526E /S3526E FM /S3526E
FS /S3526C Ethernet Switches support the Auto Detecting feature.
1.1 Introduction to Auto Detecting
Auto detect is a function that detects the connectivity of a network regularly using ICMP
request/rely packets.
Auto detect is carried out through detecting groups, which contain IP addresses of
interfaces to be detected. You can examine the connectivity of a network by checking
the results of detecting groups, which in turn enables you to locate network problems in
time and take proper measures.
1.1.1 Configuring Auto Detect
Table 1-1 Configure auto detect
Operation
Enter system view
Create
group and enter its view
Configure
address of the interface
to be detected in the
detecting group
Specify
detecting
generated
Specify the detecting
interval
Specify the maximum
retries
detection
<Quidway> system-view
a
detecting
[Quidway] detect-group group-number
an
IP
[Quidway-detect-group-X]
lis-number
[ nexthop ip-address ]
how
the
[Quidway-detect-group-X] option [ and
result
is
| or ]
[Quidway-detect-group-X] timer loop
seconds
[Quidway-detect-group-X]
during
a
retry-times
Huawei Technologies Proprietary
Chapter 1 Configuring Auto Detecting
Command
ip
address
1-1
Remarks
–
Required
detect-list
ip-address
Required
Optional.
Defaults
and.
Optional.
Defaults to 15
seconds.
retry
Optional.
Defaults to 2.
to