Ntp Display And Debugging; Typical Ntp Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
Table 7-14 Set the maximum local dynamic sessions
Set the maximum local dynamic
sessions
Restore the default value of the
maximum number of local dynamic
sessions
By the default, the number of local dynamic sessions is 100.

7.3 NTP Display and Debugging

After completing the above configurations, you can use the display command to show
how NTP runs and verify the configurations according to the outputs.
In user view, you can use the debugging command to debug NTP.
Table 7-15 NTP display and debugging
Display the status of NTP service
Display the status of sessions maintained by
NTP service
Display the brief information about every NTP
time server on the way from the local
equipment to the reference clock source.
Enable NTP debugging

7.4 Typical NTP Configuration Example

I. Configure NTP server
1) Network requirements
On Quidway1, set local clock as the NTP master clock at stratum 2. On Quidway2,
configure Quidway1 as the time server in server mode and set the local equipment as
in client mode.
2) Networking diagram
Operation
Operation
Huawei Technologies Proprietary
7-10
Chapter 7 NTP Configuration
Command
ntp-service max-dynamic-sessions
number
undo ntp-service max-dynamic-sessions
display ntp-service status
display ntp-service
[ verbose ]
display ntp-service trace
debugging ntp-service
Command
sessions